Deck resoration
One of the projects I want to tackle on the old mako this winter is to restore the non skid deck on her. On one of the trips to PLO this season I went to reach for one of the outrigger lanyards and my feet started to go out from under me. Not a good thing to happen in December. So Dale and I will be stripping her down and spraying new gel coat with non skid additive. Any suggestions or hints on such a project would be greatly appreciated. I just hope I can get gel coat on deck to match the old so I am not redoing inside gunnels and cabin to make them match. I figure I would mix a little rockfish blood in with gel coat and it should be a perfect match. LOL! Anyhow I will continue with posts and pictures of the progress. Wish us luck!
|
I'm not saying I would do it to my boat, but have you looked at the photo's of boats done with "Line X"? The "scrap book" they have at the shop looks pretty interesting.
5th |
I have seen them done with line x. Only problem is the added weight and if you ever have to remove a plate in the future, I.e. To get to fuel system it is a ***** to break the seal around the plate and to get recaulked to another water rite seal due to its texture. And it will chip when something such as 24 oz weight was dropped on it. The line x I have had in trucks did the same. Taking truck back for repair no biggie but dragging the boat would be pain in the ass!
|
1 Attachment(s)
Some pics from deck plate removal
|
3 Attachment(s)
I highly recommend gel coat if you can. If not, my dad redid his deck with epoxy deck paint with some sand in it and it works well. Below is a photo being repainted after nearly 4 years of use. The epoxy holds up well and gives protection. Needs to be redone every few years and It is tougher to clean than gel coat. However it is a tough finish.
|
1 Attachment(s)
Thanks for the feedback Greg. When you said after four years of use did you mean with the product he used to recover it? I found a petit product that has the mica mixed in with the paint and looks easy to use. Best part is that it comes in a color that is almost identical to the current color. How in the heck do you put more than one photo in a post!
|
The first coat of epoxy lasted 4 years. It was gel coat before that but was getting too smooth. He said he fell trying to gaff a fish and went with the epoxy then.
|
I just use the Interlux Interdeck paint. Takes a little over 3 quarts to do the deck on my 42'. The non-skid is very good without being overly aggressive and will last a couple of years if you're not trying to destroy it. Just use it straight out of the can - it may seem too thick while you're stirring but it works perfectly.
|
Quote:
|
1 Attachment(s)
Today we got all deck plates sanded wiped down fairing compound in all dings, cracks and whatnot. Sanded again, wiped down again and finally first coat of petit nonskid paint.coming along and is turning out pretty nice.
Never realized how many dings and chips were on the deck. Guess I gotta start being a little more careful with the 29 oz. weights. |
1 Attachment(s)
After first coat
|
Mike; that looks great. You can get a lot done indoors:D
5th |
Looks good Mike. Good to see you Saturday in Frederick.
|
Good seeing you as well Bruce. Personally I thought it was a great show with one heck of a turn out! Prices on most items were reasonable and there was a wide selection of items to choose from. I mostly just purchased some jig heads, some bkd's and other assorted jigging tails. Again as I mentioned at the show, if you need a hand figuring out the problem with your control station please feel free to contact me, would love to help as much as my knowledge will allow. Sorry I didn't get back by your table but was getting a little crowded and I got outta there. Sounds like there could be a fair amount of snow this weekend for the Kent island and Tristate shows. If that is the case defiantly glad I made it to Frederick show. Stay off the ice and snow and take care of that hip!
|
1 Attachment(s)
A few more pictures of progress. Sanded and masking edges
|
1 Attachment(s)
First coat of non skid being applied to actual deck. And like I thought looks so good now all smooth finished areas will be painted. God it's nice to work indoors during the winter!
|
Are you at the place off of 97? If so, what is the indoor temp there. I may want to finish under the gunwales of dad's boat with grey before the Judge Yachts open house if I cannot come to terms with a current perspective buyer. :)
|
Quote:
|
Greg; I am in the indoor place off 97. They do keep it at 50* and they are full. They allow washing outside, not inside. Waxing is also done outside, not inside where the "dust" can get over other boats. I can't believe they would allow painting inside.
5th |
1 Attachment(s)
Got deck put back together and new transducer cable ran. Now sanding all top sides prepping for paint.
|
It's looking really good, keep the pictures coming. Your probably saving a pretty penny doing the work yourself, that means you can buy 1st round on Saturday!
|
Gunnels have all dings chips and dents filled from the sound of 20oz + weights thumping on gunnels,especially on the port side from years of sash weights beating on them from deep dropping and sword fishing. All have been sanded and taped just waiting on paint to be applied. Hopefully get at least one coat on before the weekend due to PSG show this weekend doubt much will get done. Show no big hang up but the big head Sunday from meeting at Irves following the show may hinder the progress!
|
Done for winter
1 Attachment(s)
Deck is done on the entire boat. Have all non skid surfaces painted as well as all cockpit smooth surfaces. Just running out of time to complete entire project this winter. Time to start working on rods/reels and tackle for upcoming season so we can put some blood on them new decks!
|
Looking good!!!!
|
You guys did one hell of a job, turned out great!
|
Quote:
|
I can't wait to see her in the slip at our marina.
p.s. Looks like I may have a slip in Deale for Trophy season:D I'll see you back up north June 1st:) 5th |
Quote:
|
Sure you're invited on a trip. Have to teach you how to set 20 lines this spring:)
I'm just worried that being around all the guys SOUTH of the bridge; you will pick up the "rebel" label.:D 5th |
Quote:
|
Mike; have a snickers:D
Bahaaaa, look who's telling you this:eek: 5th |
Quote:
Mistake#2 - downing Trump. Better wake up and realize the reason all of the establishment is trying to take him down is because they don't own him. They can't control him. If he doesn't win, the Dems, Mexicans, Latinos, Blacks, Towel heads, Clintons, own Amerika from now on. |
All times are GMT -5. The time now is 05:51 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Ad Management plugin by RedTyger