Thanks, as soon as I thought about sliding the shrink tubbing over the wire; I thought "chit" I should have layer the wires horizontal before twisting them
I'm sure that tomorrow (when there is less boat traffic in our creek) I will be able to KEEP the soldering gun under the wires long enough to get them hot and "absorb" the solder.
I was trying to cheat and kept putting the solder on the tip of the gun and expected it to run as a liquid over the bare wire
Even a subtle wave makes me look like I have the shakes and keeps me from getting a good seal.
The light is working with electrical tape wrapped around it
But I know it would corrode in a very short time if left in it's present condition.
I just marvel at how a 20 minute job will take me two days to complete. Nothing on the boat is done half-assed; I don't want to start now.
Thanks Mikie for confirming the proper way to do it
5th